American Standard 3174.002-0070A Manual de Instruções

Consulte online ou descarregue Manual de Instruções para não American Standard 3174.002-0070A. American Standard 3174.002-0070A Instructions / Assembly Manual do Utilizador

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
  • Página
    / 1
  • Índice
  • MARCADORES
  • Avaliado. / 5. Com base em avaliações de clientes
Vista de página 0
1
Champion4 Valve Replacement Instructions
Turn off and disconnect the
supply line. Drain the tank
by lifting tower.
Sponge out any remain-ing
water. Detach the hook
from lift arm.
Disconnect the refill tube
from the tower. Detach the
tank from bowl by removing
tank fasteners. (not shown)
Place the tank on it’s side,
remove the coupling
gasket (not shown) and
lock nut.
Remove the old flush
tower and discard.
Install a New Champion4
Flush valve with the vent
tube positioned as
shown.
Tighten the lock nut hand
tight plus an additional ¾
turn.
Align the lock nut “flat
parallel to back edge of
tank.
Remove 2 inches
(50mm) from the end of
the refill tube; save the
“S” clip for the next
step.
Re-insert the S” clip
into the end of the
refill tube.
Affix the end of the
refill tube to the valve
overflow at the location
shown.
Alternate view of the
refill tube attachment.
Remove the Hair Pin Cotter
from the new Clevis Pin
assembly. Insert the clevis
pin through the inbound
hole location.
Re-insert the hair pin
cotter through the clevis
pin hole.
Properly configured
Champion4 Flushing
System.
Replace the coupling
gasket over the lock nut,
re-fit the tank assembly to
the bowl and tighten the
tank mounting fasteners in
a alternating manner. Re-
connect the water supply.
Adjust the water level to 1
inch below the overflow
tube. Replace the tank lid.
ISPN 7301121-100A
Vista de página 0
1

Resumo do Conteúdo

Página 1

1Champion4 Valve Replacement InstructionsTurn off and disconnect the supply line. Drain the tank by lifting tower. Sponge out any remain-ingwater.

Comentários a estes Manuais

Sem comentários